Chain Feeding Rotary Die Cutting Machine For Corrugated Paperboard Carton Box

INSTALLATION AND ADJUSTMENT

Installation:

1. Put machine main unit in flat cement floor, then use lever instrument to measure flat, error not over 0.1‰, make complete machine is flat.

2. Connect feeding table with main unit: Connect Left front under chain wheel with gear of feeding shaft by chain, fix right front with main unit by bolt. Then Fix left side control box and right side cover.

3. After finish all of prepare work, then connect electricity and take no load running (Clean all of tools and junk). Check machine flat or not, have noise or not, ensure normal then start work.

Install wooden mould:

Put the wooden die in anywhere, make M8*25 bolt to fix die on the lower roller, the order from middle to both side, and then around circumference, let die cling to the roller surface. When use two dies, must attend connect place and let cutter edge is flat.

Connect air compressor:

Take air tube connect the air compressor with the FRL that under the left side operation box, and open the pressure valve, send air to machine.

Start On Machine:

Connect power, press “M. unit ON” button, indicator light; then press the bell to alarm safety; then press “air pump ON”, indicator light, provide air to machine; Switch on speed controller, rotate knob speed up, feeding sheets, turn the “lift roller” knob to middle.